How to reduce the error rate of electric spindle operation

//How to reduce the error rate of electric spindle operation

How to reduce the error rate of electric spindle operation

The failure rate of reducing the operation of the electric spindle is related to the proficiency of the operator. On the other hand, it is related to the steps of installation, cleaning and maintenance of the electric spindle. DECI ATC spindle motor want to share with you three points  how to cut down the error rate . The following content will focus on 60000rmp atc spindle motor .

  1. We must connect the inlet and outlet pipes of the electric spindle according to the corresponding requirements, and also see if he has any water leakage. From the start to the stop, the cooling system must be operated continuously. The coolant should be used separately. And the coolant is replaced every month. We need to match the power, frequency and voltage of the inverter and the electric spindle. The current of the inverter should be set according to the current of the 60000rmp atc spindle motor .
  2. When the 60000rmp atc spindle motor is used for loading, we need to clean the taper holes on the shaft head, and also clean the dirt on the upper surface of the spring chuck, so that the accuracy can be effectively prevented. To clamp the electric spindle nut, we must be careful not to use excessive force. In addition, the bearing that contacts the ball has a speed limit, so the electric spindle cannot be overspeeded. If it is overspeed, the bearing of the precision contactor will burn out.
  3. If you hear an abnormal sound in the electric spindle, then we must check him and touch the electric spindle for heat and vibration. If there is any, we have to check it off and see if the quality is stable during processing.

The above brief introduction helps you to control the error rate of the electric spindle operation from three aspects, and cooperates with the skilled skill of the staff. It is believed that the error rate can be greatly reduced, and it is also a kind of protection for the 60000rmp atc spindle motor

By | 2018-07-08T12:27:51+00:00 July 8th, 2018|Uncategorized|0 Comments

About the Author:

Leave A Comment